PCB Libraries Forum Homepage
Forum Home Forum Home > PCB Footprint Expert > Questions & Answers
  New Posts New Posts RSS Feed - PLCC
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

PLCC

 Post Reply Post Reply
Author
Message Reverse Sort Order
magnus.lictor View Drop Down
Advanced User
Advanced User
Avatar

Joined: 27 Aug 2012
Location: Amsterdam, NL
Status: Offline
Points: 60
Post Options Post Options   Thanks (0) Thanks(0)   Quote magnus.lictor Quote  Post ReplyReply Direct Link To This Post Topic: PLCC
    Posted: 31 May 2021 at 11:34pm
Tom,

Thanks for your reply. Did not recognize this dimension as the Terminal Lead Center.

And you are right, that dimension is in my datasheet.

Thanx, Charles
Back to Top
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5716
Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 31 May 2021 at 9:01am
D2 = The Terminal Lead Center. 

Most PLCC mfr.'s provide that dimension. 

Stay connected - follow us! X - LinkedIn
Back to Top
magnus.lictor View Drop Down
Advanced User
Advanced User
Avatar

Joined: 27 Aug 2012
Location: Amsterdam, NL
Status: Offline
Points: 60
Post Options Post Options   Thanks (0) Thanks(0)   Quote magnus.lictor Quote  Post ReplyReply Direct Link To This Post Posted: 31 May 2021 at 5:42am


Hi,

Can you tell me what the D2 dimension stands for. As it is not a dimension in my datasheet but required by the footprint designer.
And, when the D2 dimension is not applicable what should I use?


regards, Charles
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.172 seconds.