Print Page | Close Window


Printed From: PCB Libraries Forum
Category: PCB Footprint Expert
Forum Name: Questions & Answers
Forum Description: issues and technical support
Printed Date: 27 May 2024 at 2:50pm

Topic: PLCC
Posted By: magnus.lictor
Subject: PLCC
Date Posted: 31 May 2021 at 5:42am


Can you tell me what the D2 dimension stands for. As it is not a dimension in my datasheet but required by the footprint designer.
And, when the D2 dimension is not applicable what should I use?

regards, Charles

Posted By: Tom H
Date Posted: 31 May 2021 at 9:01am
D2 = The Terminal Lead Center. 

Most PLCC mfr.'s provide that dimension. 

Stay connected - follow us!" rel="nofollow - X -" rel="nofollow - LinkedIn

Posted By: magnus.lictor
Date Posted: 31 May 2021 at 11:34pm

Thanks for your reply. Did not recognize this dimension as the Terminal Lead Center.

And you are right, that dimension is in my datasheet.

Thanx, Charles

Print Page | Close Window