PCB Libraries Forum Homepage
Forum Home Forum Home > PCB Footprint Expert > Product Suggestions
  New Posts New Posts RSS Feed - Adding Pin 1 Dot on Assembly Layer
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Adding Pin 1 Dot on Assembly Layer
 Post Reply Post Reply Page  <123
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Online
Points: 5906 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: Yesterday at 8:34am
In V25.10 we added a new feature to replace the Assembly Polarity Chamfer with a Dot. 

Now you want us to add a new feature to allow the user to place the new Assembly Dot in the same location as the Silkscreen Polarity Dot. 

V25.10 is the last release this year and we're currently preparing it for the official release next week in October. 

We might be able to do that in V26 next year. 
Stay connected - follow us! X - LinkedIn
Back to Top
 
Back to Top
m.elsayed View Drop Down
Advanced User
Advanced User


Joined: 22 Sep 2016
Status: Offline
Points: 131 		Post Options Post Options   Thanks (0) Thanks(0)   Quote m.elsayed Quote  Post ReplyReply Direct Link To This Post Posted: 11 hours 43 minutes ago at 8:37pm
I think this parameter releated for feature added not new feature from scratch
Even our discussion shows it requested from start so feature can be helpful 
Back to Top
tgrodnicki View Drop Down
Advanced User
Advanced User


Joined: 30 Sep 2014
Status: Offline
Points: 141 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tgrodnicki Quote  Post ReplyReply Direct Link To This Post Posted: 9 hours 6 minutes ago at 11:14pm
The polarity marker on the Silkscreen layer (as it's used for post-assembly inspection) is outside the footprints's outline.
For the Assembly layer, I prefer to place the marker inside the outline.

If Footprint Expert will have an option to place it in the same location as the dot on the Silkscreen layer, I'll probably never use it.
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Online
Points: 5906 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 12 minutes ago at 8:08am
Here is the new Assembly Polarity Dot in a SOP footprint. 


 
You can select the Minimum / Maximum dot diameter in Assembly > Options. 

You can toggle between Assembly Chamfer and Dot, whichever you like best. 

Options are not saved to FPX. Options are automatically applied when you open a footprint. 
Stay connected - follow us! X - LinkedIn
Back to Top
 Post Reply Post Reply Page  <123

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.217 seconds.