![]() |
|
Molded Body - Cap, Polarized Calculations |
Post Reply
|
| Author | |
ccyman
New User
Joined: 17 Jul 2026 Status: Offline Points: 2 |
Post Options
Thanks(0)
Quote Reply
Topic: Molded Body - Cap, Polarized CalculationsPosted: 13 Nov 2026 at 4:11pm |
|
Hi,
Is there perhaps a setting I need to fix in the calculator when using it out of the box for Molded Body - Capacitor, Polarized? The toe and heel results are not what I'm expecting to see based on the settings defined. Since I can't upload images, here's what the settings were: Component dimensions filled in were (mm): A = 2.00 max b = 2.20 +/-0.2 D = 3.50 +/-0.2 E = 2.80 +/-0.2 L = 0.80 +/-0.3 Terminal Density Level Inward Flat Ribbon L-Lead. Height > 1.20, <= 2.20 mm Density Level = Nominal Toe = 0.05 mm Heel = 0.45 mm Side = 0.00 mm Calculator results are: G = 1.33 mm X = 1.63 mm Y = 2.40 mm This results in a toe of 0.088mm (I was expecting 0.05mm) and a heel of 0.442mm (I was expecting 0.45mm). These results are from Footprint Expert 26 (26.10, 10/30/2026).
Thanks, Cindy |
|
![]() |
|
|
|
![]() |
|
Tom H
Admin Group
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 6108 |
Post Options
Thanks(0)
Quote Reply
Posted: 1 hour 31 minutes ago at 8:43am |
|
The Molded Body Toe is under the package.
The 0.05 mm Toe solder joint goal is the basic value in Options and the Tolerances are added to create the resulting value. When using the Min/Max calculation Mode, solder joint goals + Tolerances = final pad protrusion. |
|
![]() |
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |