PCB Libraries Forum : PLCC https://www.PCBLibraries.com/forum/ Tue, 07 Apr 2026 14:26:39 +0000 Mon, 31 May 2021 23:34:09 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.07 360 https://www.PCBLibraries.com/forum/RSS_post_feed.asp?TID=2920 <![CDATA[PCB Libraries Forum]]> https://www.PCBLibraries.com/forum/forum_images/PCBLForumLogo.gif https://www.PCBLibraries.com/forum/ <![CDATA[PLCC : Tom,Thanks for your reply. Did...]]> https://www.PCBLibraries.com/forum/plcc_topic2920_post11638.html#11638 Author: magnus.lictor
Subject: 2920
Posted: 31 May 2021 at 11:34pm

Tom,

Thanks for your reply. Did not recognize this dimension as the Terminal Lead Center.

And you are right, that dimension is in my datasheet.

Thanx, Charles
]]> Mon, 31 May 2021 23:34:09 +0000 https://www.PCBLibraries.com/forum/plcc_topic2920_post11638.html#11638 <![CDATA[PLCC : D2 = The Terminal Lead Center.Most...]]> https://www.PCBLibraries.com/forum/plcc_topic2920_post11634.html#11634 Author: Tom H
Subject: 2920
Posted: 31 May 2021 at 9:01am

D2 = The Terminal Lead Center. 

Most PLCC mfr.'s provide that dimension. 

]]> Mon, 31 May 2021 09:01:15 +0000 https://www.PCBLibraries.com/forum/plcc_topic2920_post11634.html#11634 <![CDATA[PLCC : Hi,Can you tell me what the...]]> https://www.PCBLibraries.com/forum/plcc_topic2920_post11633.html#11633 Author: magnus.lictor
Subject: 2920
Posted: 31 May 2021 at 5:42am



Hi,

Can you tell me what the D2 dimension stands for. As it is not a dimension in my datasheet but required by the footprint designer.
And, when the D2 dimension is not applicable what should I use?


regards, Charles
]]> Mon, 31 May 2021 05:42:32 +0000 https://www.PCBLibraries.com/forum/plcc_topic2920_post11633.html#11633