Thermal Pad Issue

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I can adjust Thermal Pad by this parameter, but when open in Altium gives wrong value.
Can have more explain how to adjust this?

uploads/11979/nm.jpg

uploads/11979/exposed_pad_paste_mask=-3.2_same_as_size.jpg

uploads/11979/ep.fpx

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
m.elsayed Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 22 Sep 2016 Status: Offline Points: 72	Post Options Post Reply Quote m.elsayed Report Post Thanks(0) Quote Reply Topic: Thermal Pad Issue Posted: 22 hours 24 minutes ago at 5:56pm
	I can adjust Thermal Pad by this parameter, but when open in Altium gives wrong value. Can have more explain how to adjust this? uploads/11979/nm.jpg uploads/11979/exposed_pad_paste_mask=-3.2_same_as_size.jpg uploads/11979/ep.fpx



Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5865	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 22 hours 5 minutes ago at 6:15pm
	80% Paste Mask Reduction will not give you a Checker Board Pattern. 80% Paste Mask Reduction will provide a single paste mask aperture. 70% is the highest Paste Mask Reduction to generate a Checker Board Pattern.
	Stay connected - follow us! X - LinkedIn

m.elsayed Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 22 Sep 2016 Status: Offline Points: 72	Post Options Post Reply Quote m.elsayed Report Post Thanks(0) Quote Reply Posted: 18 hours 32 minutes ago at 9:48pm
	i have attached fpx, can please we have explain on it , if 80% not applicable why tool not block user , rather than get wrong values, please add more details for this point, when apply 70 % what values should appears in Altium

Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5865	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 8 hours 51 minutes ago at 7:29am
	You must consider all the rules. You have a Minimum Paste Mask web set to 0.20 mm. You need to keep the Thermal Pad Paste Mask 0.10 mm indented from the pad edge. 80% is doable however, you're not going to get a Checker Board Pattern. Many users set Thermal Pad Paste Mask to 100% and allow the Assembly Shop Stencil Mfr. design the paste mask reduction. All we're saying is that we found out that 70% is the highest you can go a still get a Checker Board Pattern. We're not going to limit the software program and not allow 80%. If you're not educated on the mathematics of paste mask reduction, and the consequences of your Option settings, that's not our responsibility. It's trial and error.
	Stay connected - follow us! X - LinkedIn