FIXED / ENHANCED:

• Calculator:
• Added Polarized Inductors to the Through-hole > Radial (Inductor) family
• DFN component family: when using the mfr. recommended pattern, the DRC rules prevented you from entering dimensional data that violated the rules
• SOT223 component family: when changing the pad shape to Rectangular, Pin 1 pad stack matched Pin 4
• TO DPAK: when using the mfr. recommended pad stack, if the pad was wider than the component body the program removed all silkscreen outlines
• QFN component family: fixed silkscreen for high-density packages
• Corner Concave Oscillator: added wrap-around silkscreen for small packages
• Minimum Solder Mask Gap was not adhering to the rules and Gang Mask was not working properly
• Local Fiducials: In certain situations in QFP, the program was not following user preferences for adding fiducials only when the pin pitch is below a user defined value
• FP Designer:
• Square pad shape produced a round solder mask
• The feature to add multiple pins with the same pin number has been restored
• When creating a Round Body part, adding pads effected the silkscreen diameter
• Non-plated hole pad stack names did not include the pad size 
• Library Editor:
• When Copy/Paste or Import FPX if the Part Number already existed the warning would indicate the Footprint Name and not the Part Number
• When deleting rows of data from an FPX file and then Import FPX, the new imported data was not organized at the end of the FPX file
• When coping a row from one FPX file to another, the RMB Paste threw an error message
• Library Column sorting only happens when a column header is clicked
• Value changes no longer result in row order updating
• Find/Replace should work much better now
• Improved the Sort by Column feature
• Preferences:
• Grid Array preferences were locked and un-editable
• On a new installation, when you select “Save As > File Name” the program does not recognize the new Preference file until you select “Open File” and select your new FPX file
• User footprint name Suffix is now applied to every part in your FPX file
• Some Terminal > Through-hole preferences were not being saved properly
• Allegro/OrCAD PCB:
• Fixed the scripting so that Lines which utilize non-45 degree lines draw properly
• You can now map a layer to PLACE_BOUND_TOP and it will automatically become a shape
• Mirroring for Courtyard to DFA_BOUND_TOP will only happen if Courtyard is set to PLACE_BOUND_TOP
• PADS Layout:
• Fixed a problem parsing back-to-back arcs in the PADS Decal reader
• The PADS importer now sets both height and width correctly for round thermals
• CR-5000:
• Updated the output of Centers to be vectors from the start point to the center instead of points
• EAGLE:
• Fixed a problem with drills when dealing with through-hole parts with surface mount pads
• Target 3001!:
• Fixed a point where arcs were using the Diameter instead of the Radius.
• Parts on Demand (POD):
• Added 40,000 new part numbers